Turbocoil®
High-efficiency heat exchanger with TURBOFIN® (louvered profile) aluminium fins and copper tubes with internal helical grooves.
Turbofin®
Aluminium TURBOFIN® fins with high-efficiency turbulator louvres to increase heat transfer coefficient and guarantee high performance even during frost formation.
STEEL Protected
Corrosion resistant epoxy-polyester coated galvanized steel casing.
Heat Exchanger
CHS – Compact Hitec Surface
TURBOFIN® 3 heat exchanger
The heat exchanger with internally grooved tubes and staggered rows, suitable for both positive and negative temperature applications for the conservation of products with low humidity content, or packed products.
LHS – Large Hitec Surface
TURBOFIN® 4 heat exchanger
The heat exchanger with internally grooved tubes and in-line rows, featuring a high ratio between the secondary fin surface and the primary tube surface, suitable for conservation cold rooms for products with high humidity content, and for freezing.
Fin spacing and best use
Range 4 – 4.5 mm: conservation at positive temperature
Range 6 – 6,0 mm: conservation at positive temperature
Range 7 – 7.5 mm: conservation at negative temperature
Range 10 - 10 mm: freezing and conservation at negative temperature
Range 12 - 12 mm: freezing
DEFROST
N = air defrost (TC> 2°C)
E = electric defrost (TC> -35°C)
SB = water spray defrost (TC> -2°C)
G = hot gas defrost for coil and electric defrost in the drain tray (TC> -35°C)
GB = hot gas defrost for coil and drain tray (TC> -35°C)
CASING
Zinc coated steel casing with corrosion resistant powder coating finish
- Operating on HFC refrigerant fluids.
- NH3 Operating on ammonia.
- Operating on CO2.
